---

G21                                        ; metric values
G90                                        ; absolute positioning
M82                                        ; set extruder to absolute mode
M107                                       ; start with the fan off
M140 S{material_bed_temperature_layer_0}   ; Start heating the bed
M104 S{material_initial_print_temperature} ; start heating the hot end
M190 S{material_bed_temperature_layer_0}   ; wait for bed
M109 S{material_initial_print_temperature} ; wait for hotend
G28 X0 Y0 Z0                               ; move X/Y to min endstops
G1 Z2.0 F3000                              ; Move Z Axis up little to prevent scratching of Heat Bed
G1 X1.1 Y20 Z0.3 F5000.0                   ; Move to start position
G1 X1.1 Y200.0 Z0.3 F1500.0 E15            ; Draw the first line
G1 X1.4 Y200.0 Z0.3 F5000.0                ; Move to side a little
G1 X1.4 Y20 Z0.3 F1500.0 E30               ; Draw the second line
G92 E0                                     ; Reset Extruder
G1 Z2.0 F3000                              ; Move Z Axis up little to prevent scratching of Heat Bed
G1 X5 Y20 Z0.3 F5000.0                     ; Move over to prevent blob squish
M117 Printing...